http://www.extremepsi.com/store/customer/product.php?productid=16561&cat=262&page=1&veh=2G%20DSM

im getting these

nice. How low do you plan on dropping it?

im not sure, at least an inch.

how hard is it gonna be to install these?

shouldnt be too hard to install because you can just take off the whole stock struts with the spring still on them so it wont be as bad as doing just springs.

Oops, wrong link, the ones i ordered have pillow ball mounts

ya, putting in coils is really easy, by taking it all out at once you don't have to compress the springs or anything, unless you're using the same strut, but i suggest getting brand new ones. but its' really easy, and fun to mess around with, my car is a little on the hot rod style with my coils.

remember if you lower it any more than id say around 1.75"-2" youll start to need a camber kit, so keep that in mind

what? like if i lower it an inch or and inch and half am i ok?

ORIGINAL: TheEngineer

remember if you lower it any more than id say around 1.75"-2" youll start to need a camber kit, so keep that in mind


if you don't get a camber kit and you got it slammed with no support it could really mess up your suspension, too much stress without support.

yea i would say that 1" - 1.5" should be fine. Like he said youll exert stress on your suspension and youll get what is refered to as negative camber where the wheels will have an angle to them and youll start to notice the edges of your tires wearing as a result