nuts and bolts - identification
 

Hears the problem - when removing the head to replace the gasket due to over heat it was obvious the some of the fasteners (manifolds and a accessories) were not what/where they should have been! Minor stuff but I'd like to restore them to the proper sites and uses. And things were holding - mostly. . .

So - is there a specification some where that gives lengths, types, thread specs, drawings, or 3d renderings or photos.

For instance, cap screw with captured washer (thickness), or flanged head (needing no washer), or accepting a nut and washer to hold down some accessory.

I've never seen this in a Chilton manual or the like, tho they do have some info.

But he info has got to be somewhere. Factory schedule for assembly - some where . . .