Problem with sound controll on aftermarket Navi gps installation
#1
Problem with sound controll on aftermarket Navi gps installation
Hello Everybody !
I have been doing a lot of research and read most of the people have written on this forums. But nothing is helping with my problem. I have an Outlander 2007 with Rockford fosgate system. I installed a chinese Navi gps radio etc. Everything works - Even bluetooth, steering wheel control and reverse camera too. But the problem is with the sound. I cannot controll the speakers - front or rear. The sound settings does not work.
Have any of you any similar problems ?? Is there any thing I can do ? Would it work with MITO-2 harness ?
The chinese seller couldn't help me.
If I connect the wiring direct to speakers (without rockford amp) would the speakers work ? And what about the sub then ?
I need help !!!
I have been doing a lot of research and read most of the people have written on this forums. But nothing is helping with my problem. I have an Outlander 2007 with Rockford fosgate system. I installed a chinese Navi gps radio etc. Everything works - Even bluetooth, steering wheel control and reverse camera too. But the problem is with the sound. I cannot controll the speakers - front or rear. The sound settings does not work.
Have any of you any similar problems ?? Is there any thing I can do ? Would it work with MITO-2 harness ?
The chinese seller couldn't help me.
If I connect the wiring direct to speakers (without rockford amp) would the speakers work ? And what about the sub then ?
I need help !!!
Thread
Thread Starter
Forum
Replies
Last Post