RATTLE/KNOCK CEL at startup
#1
RATTLE/KNOCK CEL at startup
Hey all,
Have a 2009 outlander 4wd v6 with 145,000KM on it.
Took it in for the 144,000km maintenance..oil change, transfer case oil change, atf change, etc....
Drove it for a few days and was fine.
My girlfriend started it this morning and said there was a terrible knocking/rattling from under the hood and then noticed the CEL was on (but wasn't sure when it came on..immediately or after she turned the car off and back on). There was no oil or anything on the ground.
At this point it is driving fine now but the CEL is still on.
Any thoughts? I am getting it scanned later today.
Any chance the maintenance could have doen something that would cause a few days delay in showing up?
Thanks in advance,
Dave
Have a 2009 outlander 4wd v6 with 145,000KM on it.
Took it in for the 144,000km maintenance..oil change, transfer case oil change, atf change, etc....
Drove it for a few days and was fine.
My girlfriend started it this morning and said there was a terrible knocking/rattling from under the hood and then noticed the CEL was on (but wasn't sure when it came on..immediately or after she turned the car off and back on). There was no oil or anything on the ground.
At this point it is driving fine now but the CEL is still on.
Any thoughts? I am getting it scanned later today.
Any chance the maintenance could have doen something that would cause a few days delay in showing up?
Thanks in advance,
Dave
Thread
Thread Starter
Forum
Replies
Last Post
Randys
Mitsubishi Montero & Montero Sport
3
08-22-2011 12:02 AM
XBMRX
2nd Generation
9
06-15-2007 11:15 PM