1994 3000GT SL Parting Out (up-date)
Thread Starter
|
Member
Joined: Dec 2005
Posts: 73
From:
1994 3000GT SL Parting Out (up-date)
( Sorry if i dont reply quick im having problem w/ my internet at home, im having to dive to my parent house to answer your question. So please bare with and i opologize. thanks )
Back in August I rolled my 3000GT, But it still has a lot of good parts.
I will post pictures by this weekend. I have alot of extra parts also.
This are some the parts that are still in very good-
1. Engine - W/ only less than 3000 miles (have all the receipts) ,
Tranny - Still Good (Ran strong when it was in my car) New Clutch ,
(Never had the Chance to Install),ECU and Short ram air intake
w/ K&N filter $2000
Clutch
-
Rear Garnish w/ left and Right tail lights - $90
Outside window molding - $85
Strut tower bar (used)- $55
Engine Torque Dampener -JDM from japan (used)- $250
Crossed drilled and slotted rotors w/ceramics brake pads all 4 (used) - $100
Indo glow Gauge cluster (really nice) - $95
Rpm,Speed,Fuel,oil press,Batt volage and temp
Left & Right fender - $200
Power Folding Mirrors from japan - $250
Spare Tire -$35
Windshield reservoir - $65
KYB GR2 Struts w/coil overs all 4 (used) - $75
heads for 1st gen 3000GT $300 (Heads Valve, Valves Spring) - Cams Being Sold Separate $200
Extra intake manifold w/ throttle body - $100
All the Interior is In Fair Condition (Black Leather)
Note: I will Clean everything Before shipping.
Thanks for looking-
Located In Bakersfield, Ca, 93309
Back in August I rolled my 3000GT, But it still has a lot of good parts.
I will post pictures by this weekend. I have alot of extra parts also.
This are some the parts that are still in very good-
1. Engine - W/ only less than 3000 miles (have all the receipts) ,
Tranny - Still Good (Ran strong when it was in my car) New Clutch ,
(Never had the Chance to Install),ECU and Short ram air intake
w/ K&N filter $2000
Clutch
-
Rear Garnish w/ left and Right tail lights - $90
Outside window molding - $85
Strut tower bar (used)- $55
Engine Torque Dampener -JDM from japan (used)- $250
Crossed drilled and slotted rotors w/ceramics brake pads all 4 (used) - $100
Indo glow Gauge cluster (really nice) - $95
Rpm,Speed,Fuel,oil press,Batt volage and temp
Left & Right fender - $200
Power Folding Mirrors from japan - $250
Spare Tire -$35
Windshield reservoir - $65
KYB GR2 Struts w/coil overs all 4 (used) - $75
heads for 1st gen 3000GT $300 (Heads Valve, Valves Spring) - Cams Being Sold Separate $200
Extra intake manifold w/ throttle body - $100
All the Interior is In Fair Condition (Black Leather)
Note: I will Clean everything Before shipping.
Thanks for looking-
Located In Bakersfield, Ca, 93309
Thread Starter
|
Member
Joined: Dec 2005
Posts: 73
From:
RE: 1994 3000GT SL Parting Out
I have then off i just need to take pictures, ill try to send them by this weekend.
( Sorry if i dont reply quick im having problem w/ my internet at home, im having to dive to my parent house to answer your question. So please bare with and i opologize. thanks )
( Sorry if i dont reply quick im having problem w/ my internet at home, im having to dive to my parent house to answer your question. So please bare with and i opologize. thanks )
Thread Starter
|
Member
Joined: Dec 2005
Posts: 73
From:
RE: 1994 3000GT SL Parting Out
ORIGINAL: 943KGT
where did you get the rotors from, are they warped any, and how much shipped to 32054? thanks
where did you get the rotors from, are they warped any, and how much shipped to 32054? thanks
( Sorry if i dont reply quick im having problem w/ my internet at home, im having to dive to my parent house to answer your question. So please bare with and i opologize. thanks )
I will try to have an aswere by this weekend
Thread
Thread Starter
Forum
Replies
Last Post
