Believe me I did a search but really didn't know what to search for. So if its been asked my bad. I got an SBR 16g and there is no place for me to run a vaccume line from the acutuator to the housing. The housing has no type cof connector on it. Can I just not run anything from the actuator and let it vent or will I need to cap it?

 

Bump

 

bump... again I really need some help on this one

 

i drilled hole in the j pipe and put a threaded nipple and connected right there

 

I know there is a vaccum line I can tie into. I've seen it done when ppl install mbc's. Any one have an idea which vaccum line I could T into? I'm not 100% but could I T it into the line that runsoff the BOV. Can any1 confirm this