I need the torque specs for all of the bolts to put my motor back together.. Anyone have a link that will give them to me? Im gonna start putting it together tomorrow when I get home from work.. So the sooner the better!

 

Nevermind, I found a site for it.

 

what was that site?

 

yes i need that site too

 

http://www.motorpower.net/specs/4g63.html

Im not sure if all of them are right.. Im still trying to confirm some of them.

 

thank you

 

thank ya sir

 

already got everything ready? what all did you end up doing? i know the 6 bolt, did you build the block? if so with what? i know you were talkin about runing some 264 cams also w/ new springs and lifters. what all did you end up doing? new turbo any time soon?! :-D

 

No, im actually putting this one back together with a new crank and bearings.. Then im gonna sell it. But I have the 6 bolt block sitting in my garage waiting for this 1 to be sold so I can build that one with rods/pistons/cams/springs and go bigger than the 20g turbo.. I have just about all of the fuel stuff that I need.. Just need a fuel pump to finish that.. So when I get the motor put together and a car to put it in Im gonna spend about 3grand in a turbo and intercooler/hard piping.. Ill let ya know when I get this one back running.. Unfortenatly they sent the wrong gaskets so I have to wait till next week to put my motor back together.. But once I sell this one, I want to start on the next right away, and have it running by spring.

 

i have the hanes manual for the 2g and 3g so if u need something specific ask and u shall recieve