HELP!!!! Getting screwed at the shop!
#13
02-16-2009, 07:28 PM
RE: HELP!!!! Getting screwed at the shop!
behind the pedal there is usually a rod that goes into the master cylinder. That is where you adjust it. I know the 2g is like that, id assume your car is pretty much the same
#14
02-16-2009, 08:01 PM
RE: HELP!!!! Getting screwed at the shop!
Just so I can diagnose, do this.
Sit on dead level ground, put the car in 1st gear, but don't lift the clutch. Then rev the car up decently, and see if it moves.
Sit on dead level ground, put the car in 1st gear, but don't lift the clutch. Then rev the car up decently, and see if it moves.
Thread
Thread Starter
Forum
Replies
Last Post
Tom
Mitsubishi Galant
1
06-25-2004 10:40 AM
