messed up the electronics, HELP!!!
#1
HELP! i messed up the electronics
today when I went to jumpstart the car, I hooked up the jumper leads backwards and fried the 120 amp fuse under the hood. I replaced that, but now the radio, clock, and the gauge lights aren't working. the gauge fuse under the dash was blown, I replaced that, but still no lights.
what can i do now besides replace the gauges? is there something else that controls all these things that i need to replace now? this is my bosses daughters car, so i need to get it figured out.
what can i do now besides replace the gauges? is there something else that controls all these things that i need to replace now? this is my bosses daughters car, so i need to get it figured out.
Last edited by Raider; 05-01-2015 at 10:54 AM.
#2
the signal lights work, the high beam light works, its just the clock, the radio and the speedo/tach lights that are not working.
should I try replacing the speedometer assembly to see if that fixes it? maybe each component is fried?
could it be the ecu that's fried?
anyone have ANY idea's???
should I try replacing the speedometer assembly to see if that fixes it? maybe each component is fried?
could it be the ecu that's fried?
anyone have ANY idea's???
#3
Everything is fused for protection, therefore I would not start replacing components without verifying all fuses first. I do note that in the electrical schematics that the Audio, Cruise, Center Display,power antenna, and clock operate off the same fuse link.
Thread
Thread Starter
Forum
Replies
Last Post