I think its time to finally give up being a kid. I have a family now and spending money on cars probably doesn't fit into the budget anymore. Most of you know me and what I have done with the car.

1995 Eagle Talon TSI AWD
4E3AL54F6SE004687
~140000 Miles on the car
400 Miles on the new Engine

Engine 2.5L 4g63/64 hybrid

block:
8.5-1 JE pistons
Pro seal rings
acl main bearings
king rod bearings
new polished crank
Scat H-beam rods
Balance shafts eliminated
ARP main, rod, and head studs
New water/oil pump
bored 40 over and hot tanked
Mitsu 4 layer MHG
Fluidampr harmonic dampener

Head:
1g ported and polished head
Supertech dual valve springs
ferra 1mm oversized valves
3g lifters
Comp 101200 camshafts

Induction
Dejon tool 1g intake pipe (relocates filter to old side mount intercooler location)
PTE SCM50 turbo
Slow Boy racing front mount intercooler w/ piping
Tial blow off valve
GM 3” MAF sensor
1G throttle body
JMF Race Intake manifold w/ nitrous bungs (just in case)
SBR manual boost controller (AEM truboost doesn't do it for me)

Exhaust

evo3 port matched exhaust manifold with EGT probe and JMF heat shield
VRS 3” turbo back exhaust with o2 delete

Cooling
Ebay oil cooler
GReddy Oil catch can
Goodridge Oil feed line
Earls Oil feed filter
Slowboy racing SS Oil return line
Mishimoto aluminum radiator
Flex-a-lite slim line fans


Fuel
OBX fuel rail
Aeromotive adjustable fuel pressure regulator
FIC 1000cc fuel injectors
Walbro 255lph hi flow pump
-6 an stainless steel fuel lines tank to filter
-6 an stainless steel fuel lines filter to rail
-6 an stainless steel fuel lines rail to fuel pressure regulator

Drivetrain

MachV shifter bushings
Prothane motor mounts
ACT 2600
ACT pro lite flywheel
New slave and master cylinder with complete ss line in between

Misc.
Cole Hersee # 48120-140 Amp Battery Isolator
Razco RZ lightweight pulleys
Ace alternators 140amp alternator

Exterior

Drift Front bumper
Angel eyes black housing headlights
VIS evo style carbon fiber hood
Bosche Icon windshield wipers
Sparco hood pins
Nokya hyperwhite bulbs
AIT racing wide body kit
Motegi Knock Off Rims
Autoloc shaved door handle kit with SPAL solenoids
Stainless steel fuel door
Carbon fiber tail lights
Bomex rear bumper
GT style spoiler (carbon fiber)
97 style reverse lights

Interior

Carbon fiber
Topshopheadliners carbon fiber door panels
Topshopheadliners carbon fiber door sills
Concepts to reality carbon fiber glove box
Concepts to reality carbon fiber center console
Concepts to reality carbon fiber arm rest
Eurostyle carbon fiber gauge overlay
Real carbon fiber shift boot
Topshopheadliners carbon fiber head liner

Tuning
machv triple gauge pod
DSMlink V.3
GReddy EGT gauge
AEM UEGO wideband gauge
AEM Truboost gauge
Custom laptop mount

Misc.
White HVAC gauge overlays
Sparco knock off evo2 seats
No name seat harnesses
S-7 3D gauges
HKS turbo timer
Innovex 7” motorized screen
Pioneer DEH-6700 headunit
Toshiba 9” sunvisor monitors
OBX titanium pedals
Ultimate Performance short shifter
Symborski shift kit
Autozone power inverter
Autozone battery box
Autozone marine battery
Black carpet

Recently replaced parts
Front Lower control arms
Passenger upper control arm
Transfer case recall performed
Clutch fork
Pivot ball
Throw out bearing
axle seals
Silicone vacuum lines
Silicone coolant bypass hoses
Radiator hoses
Heater hoses
valve cover
valve cover gasket (OEM)
Ignition transistor pack
In tank and engine bay fuel filters
Timing components:
-Hydraulic tensioner
-idler pulley
-tensioner pully
-Timing trigger plate
Front o2 sensor
rear o2 sensor
Knock sensor
Fuel injector o-ring kit
Fuel injector connectors
Idle speed motor
Throttle Positioning sensor
Throttle shaft seals
Biss screw kit
FIAV block off plate
1G throttle body gaskets
Powerstop Drilled/slotted rotors F+R
Carbotech Performance pads
Upper door trim
lower window trim
Front wiper arms (not installed)
Oil Cap
Oil dip stick
Cam seals (OEM)

I'm sure i'm forgetting stuff. I've put a lot of money into the car and i know I won't get it all back. This car will make someone very happy. It may be ugly but its very very fast. There are a couple of issues like all cars have.

Needs paint and some body work
Window switch on drivers side fell into door (probably could glue it or get a new door trim piece)
Small tear in drivers seat from getting in and out
I just fixed the oil leak from the cam seals so that should be good.

If you have any questions or want more pictures please let me know.

Michael Gain
michael.gain@us.army.mil
270-307-4002

 

i put this up on ebay if anyone is interested

http://cgi.ebay.com/ebaymotors/ws/eB...DLVI%26ps%3D54

 

Bump for a sick car.

 

Thanks brother I appreciate it! It didn't sell on ebay, but maybe i'll just keep it. I live on post and its really sad to see SRT-4's thinking they are the $h!t. Its still for sale, but I'm not in a hurry if it doesn't ;-)

 

Glad to see your keeping it.

 

Thanks brother. I do love it. I'll keep it and enjoy it until it sells, but it doesn't matter to me if it doesn't. Theres a lot of blood and sweat in this build, not to mention money haha. I got a 350z and it definitely isn't even close to being as fast or fun.

 

I'm conflicted.... its back up on ebay
http://cgi.ebay.com/ebaymotors/ws/eB...STRK:MESELX:IT

 

Sold!!!

 

Did you get what you asked for?

 

haha no. I only got 7000 but they paid in cash. Like i know what to do with cash haha. oh well it was a fun ride. I'm gonna miss her. I did a lot of work.