great ideas, but NEED MORE CLUTCH HELP
#11
RE: clutch??? PLEASE HELP!!!!
that can't be the case though, cause i replaced everything that touched the firewall. it's like there's not enough fluid going to the release cylinder. i think that might be what i have to replace though, i'm gunna go buy it and try that out, if that does'nt work, then i dunno
#12
RE: clutch??? PLEASE HELP!!!!
It is very unlikly but the new part may have issues. because the piston in there sould push enough fluid to push the rod on the slave to the throwout berring in the tranny. so the fluid is going somewhere wether piston in the mater or slave is not working is the case because there are no leaks so i seal on one has been blown.
#18
RE: clutch??? PLEASE HELP!!!!
Fixed it!!! thanks for the help everone. replaced the slave and master cylinder (slave cylinder (or release cylinder) by the tranny and master cylinder by the firewall. thanks again for the help
Thread
Thread Starter
Forum
Replies
Last Post
earthspresident
Everything else
0
10-26-2008 11:56 AM
theddy
Mitsubishi Outlander
7
09-20-2007 08:24 PM