Axle pops out of pass side after seal replacement. Ideas?
Thread Starter
|
Junior Member
Joined: Mar 2016
Posts: 1
Axle pops out of pass side after seal replacement. Ideas?
09 Lancer ES... I replaced my passenger axle seal after I noticed a bit of fluid in the driveway. The seal looked OK just hard and dried out.
After replacement I wend for a quick test drive. This time it was a pretty steady drip after the drive. Looked underneath and the axle popped out. I double checked everything was installed properly but it keeps happening.
What holds the axle into the trans? I don't see a clip on the trans side of the axle as I've seen in other types (mitsubishi 3000gt for example) Any help would be appreciated!
After replacement I wend for a quick test drive. This time it was a pretty steady drip after the drive. Looked underneath and the axle popped out. I double checked everything was installed properly but it keeps happening.
What holds the axle into the trans? I don't see a clip on the trans side of the axle as I've seen in other types (mitsubishi 3000gt for example) Any help would be appreciated!
Junior Member
Joined: Dec 2021
Posts: 5
Cir ring on end of axle
Was the cir ring compression ring still on the end of your axle when you put it back in? After a good push, it should lock in place and hold the axle. If not, might need to widen the cir ring a tiny bit
09 Lancer ES... I replaced my passenger axle seal after I noticed a bit of fluid in the driveway. The seal looked OK just hard and dried out.
After replacement I wend for a quick test drive. This time it was a pretty steady drip after the drive. Looked underneath and the axle popped out. I double checked everything was installed properly but it keeps happening.
What holds the axle into the trans? I don't see a clip on the trans side of the axle as I've seen in other types (mitsubishi 3000gt for example) Any help would be appreciated!
After replacement I wend for a quick test drive. This time it was a pretty steady drip after the drive. Looked underneath and the axle popped out. I double checked everything was installed properly but it keeps happening.
What holds the axle into the trans? I don't see a clip on the trans side of the axle as I've seen in other types (mitsubishi 3000gt for example) Any help would be appreciated!
Thread
Thread Starter
Forum
Replies
Last Post
