Hello,

I have a couple of questions...I am a noob to the 4wd wheel assembly deal. But I have what probably be basic questions, and then a real good question.

1. Does the wheels on the Montero freely spin when assembled? I mean is there any resistance at any point while turning it by hand?

I have reassembled the rotors, the bearings, the hub and such. When I turn the wheel with my hand but there seems to be a point that it drags. IS that normal? If not what am I looking at?

2. Is it normal for the axle boot to rotate with the wheel.


3. OK, I have everything assembled according the diagram. However, when I go to place the snap ring in place I am a little sliver shy of clearance for it to sit in the groove. I can't figure out what is keeping it from seating. The only thing that I can think it could be is the rear bearing seal. Every other part goes on only one way. It's pretty cut and dry. So what am I not seeing to get the sliver of clearance I need?

4. The rear bearing seal has a rubber side and a side that has a metal ring in it. Which side faces the wheel.


Thanks for your help!

Gene

 

1-yes 2-yes spins free 3- pull the axle out more 4-metal to wheel

 

Thanks a lot. I appreciate it.