Engine Coolant plug
Senior Member
Joined: Jan 2005
Posts: 397
Are you asking about a drain plug in the block or just the main drain for the radiator? If it's the latter it's at the bottom driver's corner of the rad pointing towards the rear. Should have a short, clear plastic drain hose attached pointing down thru the skid plate.
Ron
Ron
Member
Joined: Sep 2009
Posts: 58
They are tough to find. My factory service manual didn't mention the fact there was two of them, let alone illustrate where they were.
The passenger side plug is on the rear of the block, about 6" under the exhaust manifold. I was able to use an 18" extension from just the inside and to the rear of the front right wheel. The drivers side plug is toward the front again, just under the manifold, and looks more like a bolt than a plug. But, with all the a/c hoses brake lines and dipsticks in the way, I said "f-that" and just put a T-connector on the heater core input hose to flush the system
Although mine's a 2003 3.8, I don't expect the block to be much different.
The passenger side plug is on the rear of the block, about 6" under the exhaust manifold. I was able to use an 18" extension from just the inside and to the rear of the front right wheel. The drivers side plug is toward the front again, just under the manifold, and looks more like a bolt than a plug. But, with all the a/c hoses brake lines and dipsticks in the way, I said "f-that" and just put a T-connector on the heater core input hose to flush the system
Although mine's a 2003 3.8, I don't expect the block to be much different.
Last edited by mtc137; Oct 17, 2009 at 05:36 PM.
Thread
Thread Starter
Forum
Replies
Last Post
bkubisht
Mitsubishi Galant
3
Aug 21, 2006 06:45 AM
