Protruding Front Driver & Passenger Armrests/Door Hand Moulds
#1
Protruding Front Driver & Passenger Armrests/Door Hand Moulds
Hi Guys,
I've had my 2010 Outie LS since September 09 and it has been nothing but excellent
I noticed for a while now that the plastic armrest panel on both front doors, (the bit that the electric window button is connected to) has protruded up roughly 5-7mm from the surrounding plastic.
I can snap it back in, but within a few seconds it just pops out again...
Has anyone else had this problem?
I thought I might consult here before I investigate any further.
PS: In the back seats the plastic sits perfectly flush with no give at all, its only on the front two doors with passenger being the worst.
Cheers, Jim
I've had my 2010 Outie LS since September 09 and it has been nothing but excellent
I noticed for a while now that the plastic armrest panel on both front doors, (the bit that the electric window button is connected to) has protruded up roughly 5-7mm from the surrounding plastic.
I can snap it back in, but within a few seconds it just pops out again...
Has anyone else had this problem?
I thought I might consult here before I investigate any further.
PS: In the back seats the plastic sits perfectly flush with no give at all, its only on the front two doors with passenger being the worst.
Cheers, Jim
Thread
Thread Starter
Forum
Replies
Last Post
MrJayDeeOne
Interior
6
09-17-2010 04:16 AM
bishigt_18
Mitsubishi 3000GT
1
11-01-2008 07:24 PM
B.e.R.a.T
Private 'Wanted' Classifieds
0
01-22-2008 05:47 PM