So i am installing new white/blue at nightglow gauges. Anybody do this and how hard is it gonna be? Any tricks to get this dash off. any help fulinfo would be great. Its cold in chicago and I dont want to be stuck outside all day with this.

I have a 97 rs
Any advise on wiring this up would be great

 

it shouldnt be to difficult. To remove the dash just start taking off screws. Once you have them all off the dash will just snap off. Then the guages will just go right over the stock ones. You just need to find a place to tap into for power.

 

Will the needles just come off ? (speedo,Rpm's) so I can slide it in?

 

yea you just have to remmeber the postion they were in and make sure that they are correct after your done

 

Where and how should i run power to the gauges. It cold outside in chicago and I dont want to be out side all day. any help . Electical work kinda scares me something. Not sure what im doing. any help as basic has it might seem to you will be helpful thanks

 

Where and how should i run power to the gauges. It cold outside in chicago and I dont want to be out side all day. any help . Electical work kinda scares me something. Not sure what im doing. any help as basic has it might seem to you will be helpful thanks

 

when i had mine on my 99 gs i tapped into the cig lighter light... worked jsut fine. when you get them on, place them back in/on the car and plug it in and all. turn the key to on (just before you crank it) right then your speedo and tach should be set to 0. so place the needles on right then on 0 and they will be set correct.

 

i put them in my 97 gst... after you get the gauge cluster out you can put the face on inside that way you dont have to be outside for so long.. i am from NW Indiana bout 30 mins from chicago.. so i know what you mean about the weather especially the lake effect.. anyways it isnt that hard to put in.. make sure you hook everything up correctly and take your time otherwise you could mess some stuff up...