pcm problem
#1
pcm problem
Hey guys and girls. my problem is that i recently did the timming belt on my 1995 eclipse. i made sure all marks are lined up and every plug is connected. the car wont start , i checked for spark and fuel and is good i checked for compression and its also good, the only problem i could see would be the pcm because the shop manual says to check for voltage in the cam and crank positioning sensors which are good but i get no continuity at the certer prong for each sensor, which the book says there should be and if their in none the harness or the pcm could be bad i checked the harness for each sensor and they seem to be ok. If any one know how to reprogram a computer please let me know.(I already did the disconnecting of the battery) by the way the engine light gives me a code 12 which its supposed to be a fault in he stand by memory circuit.
Thread
Thread Starter
Forum
Replies
Last Post
fireeatn1
PCM & Fuel Systems
7
06-02-2007 06:00 PM
oops129
2nd Generation
5
01-04-2006 04:38 AM