no connection to ecu on lancer
#1
no connection to ecu on lancer
I have an Mitsubishi lancer 6 1995 with 4g92 engine.
Last week my friend connected to my car with ads scan obd adapter and laptop with single 16pin connector.
This week I received 2 different obd bluetooth adapters which I ordered from eBay.
One vgate v1.5 and the other is BAFX v1.5.
I planned to use them with torque on my sgs2, the problem is that I get "no connection to ecu" eror from torque with both of them.
Also torque wrote "connection to adapter-ok" for both.
Torque is set to thorough protocol check, I tried both once switch on position and another engine running, each for 30 min.
I can see that pins 1,4,5,6,7,8,16 are connected in the obd plug of the car .
Any ideas on why its not connecting to the ecu?which protocol does my car use?
Last week my friend connected to my car with ads scan obd adapter and laptop with single 16pin connector.
This week I received 2 different obd bluetooth adapters which I ordered from eBay.
One vgate v1.5 and the other is BAFX v1.5.
I planned to use them with torque on my sgs2, the problem is that I get "no connection to ecu" eror from torque with both of them.
Also torque wrote "connection to adapter-ok" for both.
Torque is set to thorough protocol check, I tried both once switch on position and another engine running, each for 30 min.
I can see that pins 1,4,5,6,7,8,16 are connected in the obd plug of the car .
Any ideas on why its not connecting to the ecu?which protocol does my car use?
Thread
Thread Starter
Forum
Replies
Last Post
dodge04
Mitsubishi Lancer and Lancer Sportback
1
08-31-2009 03:40 AM
ajustator
Mitsubishi Outlander
27
11-28-2007 04:18 PM