My wife bought a used 99 mirage after smashing up our GEO metro I got used to adjusting clutch cables and don't care for the hydraulic setup. The system gave out so I bought the master and slave. but can't get the fitting out of the master cylinder. These imported wrenchs just aren't any good so I'm going to buy some DeWalts. Too late now. I rounded off the high points on the outgoing fluid fitting. If you take the air cleaner off you can see what I think is a poor design. Metal tubing goes to rubber, then back again (tired today) and I think it does this one more time.
Has anyone ever found or had a shop make a tube of rubber with the correct hydraulic ends for the master and cylinder ? I need about 36" (about 9100mm) It would be so much easier to work with. Thanks