Well a couple days ago i noticed a wierd squeeling noise and a LOT of vibs when pressing the clutch and putting in gear. Well a long story short, one of the top tranny bolts was MIA, the other top was finger loose and would not tighten( wrong size bolt ) and the bottom inverted bolt near the firewall was out almost all the way. So my tranny was being held on with one bolt ! Well i went to pull n save and got some fresh used bolts. After a long time tring to match up the holes on the tranny to the block. I managed to get the top nearest the rad tight and flush, Also the one near the firewall was a B***H, but we managed to get it half way in but it is really hard to turn now. The worst part is the top tranny bolt WILL NOT TIGHTEN!! I can feel it tray to catch on the treads but it will loosen right away. There is a gap between the trans and the block right there so the holes wont line up. I need help, There has to be a trick to get these bolts on and tight! I have a 1g Talon tsi FWD.[/align][/align]thanks,[/align][/align]