OK, Got the blinker/hazard light controll box thingy in today and plugged it in. Now have brake lights working normally, but still no blinkers/hazard flashers. All fueses are ok. My question is this, I have 3 wire harness plugs under my center console. 1 goes to the ECU and is plugged in, 1 goes to this turn signal module that I just installed, the 3rd one is not plugged into anything at all. And I do not see anywhere else for it to go. Does anyone know if there is something else missing here? Haynes manual is clear as mud on this.

 

CORRECTION: 1 goes into the EFI fuel control relay, NOT the ECU as was stated. (My bad)

 

To the best of my ability, I am going to try to illustrate what this connector looks like.
Maybe this will help someone help me figure this stupid thing out. I work with Massey Ferguson and Allis Chalmers tractor service manuals allot. They have good wire diagrams. The Haynes manual (for these cars) does not !!!!


==== ====
*************
*1 2 XX3 4 *
* 56 78910 *
*************
1: Empty 2: Yellow / White stripe 3: Red / Black stripe 4: Empty
5: Black6: Green / Yellow stripe 7: Green / White stripe 8:Empty 9:Black / White stripe 10: Empty

 

im gonna be pokin around in my 91 talon tomorrow ill see if i find anything.

 

flasher ??????????

 

Actually it's pn MB802356, Buzzer, Electric...

 

Did u check out the multifunction switch?

 

evil1993Eagle, he already got his blinkers working as stated in a seprate post