UK Lancer GS4 4 Wheel Drive Conversion?
#1
UK Lancer GS4 4 Wheel Drive Conversion?
OK, not sure if this is in the right place but thought I'd asked the question.
My 2008 DiD GS4 Diesel has all the wiring needed for a 4 wheel drive system (I assume it shares all the wiring from the EvoX?) So can I get the drive train and rear axle and associated buttons etc to convert my GS4 to a 4 wheel drive car?
Any thought comments are welcome
Regards
Giles
My 2008 DiD GS4 Diesel has all the wiring needed for a 4 wheel drive system (I assume it shares all the wiring from the EvoX?) So can I get the drive train and rear axle and associated buttons etc to convert my GS4 to a 4 wheel drive car?
Any thought comments are welcome
Regards
Giles
#2
i had to google that, i didnt know there was a diesel lancer in Europe :O
what transmission do you have? you'd probably have to swap that as well, due to the center diff not being installed on your current trany, but i certianly dont see why it wouldnt be "possible"
however the AWC has quite a few electronics, so youre looking at installing the traction computers as well
give it a shot
what transmission do you have? you'd probably have to swap that as well, due to the center diff not being installed on your current trany, but i certianly dont see why it wouldnt be "possible"
however the AWC has quite a few electronics, so youre looking at installing the traction computers as well
give it a shot
#3
i had to google that, i didnt know there was a diesel lancer in Europe :O
what transmission do you have? you'd probably have to swap that as well, due to the center diff not being installed on your current trany, but i certianly dont see why it wouldnt be "possible"
however the AWC has quite a few electronics, so youre looking at installing the traction computers as well
give it a shot
what transmission do you have? you'd probably have to swap that as well, due to the center diff not being installed on your current trany, but i certianly dont see why it wouldnt be "possible"
however the AWC has quite a few electronics, so youre looking at installing the traction computers as well
give it a shot
Cheers for the reply.
Thread
Thread Starter
Forum
Replies
Last Post
Stuart_Olstrom
Intake, Headers and Exhaust
0
09-09-2011 12:59 PM