Can I Power shift or hard shif?
#11
RE: Can I Power shift or hard shif?
Then its either your master or slave cyl. If adding more fluid and pumping it didnt work.... it should work within like a min of pumping it. How long did you sit there pumping it for? Did you notice anything under the car?
#12
RE: Can I Power shift or hard shif?
Yea that's what I had read in other posts (which, funny enuff, you are in also) that it was either master or slave. I was going to check lines for leak, bleed, then replace both parts.
I didn't pump it that long. I think I should try and pump it again. I also didn't look under the car. It had rained a little or something and the street I was on was slick.
If pumping it doesn't work, does that mean it's proly one of the cylinders?
If pumping it works, what does that mean?
I didn't pump it that long. I think I should try and pump it again. I also didn't look under the car. It had rained a little or something and the street I was on was slick.
If pumping it doesn't work, does that mean it's proly one of the cylinders?
If pumping it works, what does that mean?
#13
RE: Can I Power shift or hard shif?
If pumping it works then it means you just didnt have eough fluid. Fill up the reservoir and pump the clutch for like a min. If you dont have pedal pressure back by then, then the master or slave is out.
#14
RE: Can I Power shift or hard shif?
Thanks Sebba.
One more thing, if it's one of the cylinders, should I be able to put the car in gear while it is off? I guess what I am asking is if I can't, does that mean the clutch/tranny is F$%k$% ?
One more thing, if it's one of the cylinders, should I be able to put the car in gear while it is off? I guess what I am asking is if I can't, does that mean the clutch/tranny is F$%k$% ?
#17
RE: Can I Power shift or hard shif?
Alright Sebba,
Pumping it worked. I really didn't think you had to pump it that much, but whatever. So long as it works. Now I have to check and see where there might be a leak. Is it true it's usually the slave cylinder?
Anyways, thx man.
Pumping it worked. I really didn't think you had to pump it that much, but whatever. So long as it works. Now I have to check and see where there might be a leak. Is it true it's usually the slave cylinder?
Anyways, thx man.
Thread
Thread Starter
Forum
Replies
Last Post
Eclipse440
2nd Generation
1
07-14-2015 11:08 PM
pinoyjetpilot
Mitsubishi Lancer and Lancer Sportback
0
07-15-2011 02:25 AM